Kvaser CanKing GUI Extensions SDK - v7.3.0
    Preparing search index...

    Interface LogReplaySettings

    A message for defining a log replay's settings.

    interface LogReplaySettings {
        channelIdentifiers: { [key: string]: string };
        higherVariance?: number;
        includeErrorFrames: boolean;
        increaseSpeed?: boolean;
        iterations: number;
        logFile: string;
        lowerVariance?: number;
        sampleRateMs: number;
        sendFirstMessageMode: number;
        timeFactor?: number;
        timeOffsetMs?: number;
        transceiverMode: number;
    }
    Index

    Properties

    channelIdentifiers higherVariance? includeErrorFrames increaseSpeed? iterations logFile lowerVariance? sampleRateMs sendFirstMessageMode timeFactor? timeOffsetMs? transceiverMode

    Properties

    channelIdentifiers: { [key: string]: string }

    A dictionary consisting of the channels found in the log file mapped to the channel identifiers to be used when replaying the file.

    higherVariance?: number

    Maximum waiting time variance (0-1) for how long to wait before sending the next message. The resulting range will be between the time factor and the time factor plus the higher variance.

    includeErrorFrames: boolean

    Replay error frames as well. Default value is false.

    increaseSpeed?: boolean

    Increase the speed by the time factor. Default value is true.

    iterations: number

    Number of iterations to loop the log file. Set to -1 to iterate forever. Default value is 1.

    logFile: string

    Full path to the log file to read CAN frames from.

    lowerVariance?: number

    Minimum waiting time variance (0-1) for how long to wait before sending the next message. The resulting range will be between the time factor and the time factor minus the lower variance.

    sampleRateMs: number

    Static sample rate in milliseconds to send the CAN frames at. If zero, timestamps from the log file will be used. Default value is 0.

    sendFirstMessageMode: number

    Send the first message straight away (1), after the time specified in the log file (2) or after an offset (3). Default value is 1 (send directly).

    timeFactor?: number

    Factor in percentage for speeding up or down the waiting time until sending the next message.

    timeOffsetMs?: number

    Time offset in milliseconds until sending the first message. Default value is 0. This parameter shall be used together with the mode for sending the first message after an offset (3).

    transceiverMode: number

    If only Rx (1), Tx (2), or both (3) messages shall be replayed. Default value is 1 (Rx).

    Settings

    Member Visibility

    On This Page

    Properties