Enumeration CanFrameFlag

CAN_FRAME_FLAG_ABL - Only together with TxNack, Single shot message was not sent because arbitration was lost. This flag is only used with received messages.

CAN_FRAME_FLAG_DELAY_MSG - Message is NOT sent on the bus. The transmission of messages are delayed. The dlc specifies the delay in milliseconds (1..1000).

CAN_FRAME_FLAG_ERR_BIT0 - Sent dominant, read recessive.

CAN_FRAME_FLAG_ERR_BIT1 - Sent recessive, read dominant.

CAN_FRAME_FLAG_ERR_CRC - CRC error.

CAN_FRAME_FLAG_ERR_FORM - Form error.

CAN_FRAME_FLAG_ERR_HW_OVERRUN - HW buffer overrun.

CAN_FRAME_FLAG_ERR_STUFF - Stuff error.

CAN_FRAME_FLAG_ERR_SW_OVERRUN - SW buffer overrun.

CAN_FRAME_FLAG_ERROR_FRAME - Message represents an error frame.

CAN_FRAME_FLAG_EXT - Message has an extended (29-bit) identifier.

CAN_FRAME_FLAG_FD_BRS - Message is sent/received with bit rate switch (CAN FD).

CAN_FRAME_FLAG_FD_ESI - Sender of the message is in error passive mode (CAN FD).

CAN_FRAME_FLAG_FD_FDF - Message is an FD message (CAN FD).

CAN_FRAME_FLAG_LOCAL_TXACK - Message was sent from another handle on the same can channel.

CAN_FRAME_FLAG_NERR - NERR was active during the message (TJA1054 hardware).

CAN_FRAME_FLAG_RTR - Message is a remote request, only valid for classic CAN.

CAN_FRAME_FLAG_SINGLE_SHOT - Message is Single Shot, try to send once, no retransmission. This flag can only be used with transmitted messages.

CAN_FRAME_FLAG_STD - Message has a standard (11-bit) identifier.

CAN_FRAME_FLAG_TXACK - Message is a TX ACK (msg has really been sent).

CAN_FRAME_FLAG_TXNACK - Message is a failed Single Shot, message was not sent. This flag is only used with received messages.

CAN_FRAME_FLAG_TXRQ - Message is a TX REQUEST (msg was transfered to the chip).

CAN_FRAME_FLAG_UNSPECIFIED - No flag has been set.

CAN_FRAME_FLAG_WAKEUP - Message is a WAKEUP message (SWC hardware.)

CAN_FRAME_FLAG_XL_VCID - CAN XL Virtual CAN network ID (VCID).

CAN_FRAME_FLAG_XL_XLF - CAN XL frame.