Press n or j to go to the next uncovered block, b, p or k for the previous block.
| 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 101 102 103 104 105 106 107 108 109 110 111 112 113 114 115 116 117 118 119 120 121 122 123 124 125 126 127 128 129 130 131 132 133 134 135 136 137 138 139 140 141 142 143 144 145 146 147 148 149 150 151 152 153 154 155 156 157 158 159 160 161 162 163 164 165 166 167 168 169 170 171 172 173 174 175 176 177 178 179 180 181 182 183 184 185 186 187 188 189 190 191 192 193 194 195 196 197 198 199 200 201 202 203 204 205 206 207 208 209 210 211 212 213 214 215 216 217 218 219 220 221 222 223 224 225 | 19x 1x 1x 1x 1x 1x 1x 1x 1x 1x 1x 1x 1x 1x 1x 1x 1x 1x 1x 1x 1x 1x 1x 1x 1x 1x 1x 1x 1x |
# Copyright (c) 2014 The MITRE Corporation
# All rights reserved.
#
# Redistribution and use in source and binary forms, with or without modification,
# are permitted provided that the following conditions are met:
#
# * Redistributions of source code must retain the above copyright notice, this
# list of conditions and the following disclaimer.
# * Redistributions in binary form must reproduce the above copyright notice,
# this list of conditions and the following disclaimer in the documentation
# and/or other materials provided with the distribution.
# * Neither the name of HL7 nor the names of its contributors may be used to
# endorse or promote products derived from this software without specific
# prior written permission.
#
# THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS "AS IS" AND
# ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED
# WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED.
# IN NO EVENT SHALL THE COPYRIGHT HOLDER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT,
# INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT
# NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR
# PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY,
# WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE)
# ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE
# POSSIBILITY OF SUCH DAMAGE.
DT = require '../cql-datatypes'
CORE = require('./core')
Element = CORE.Element
Resource = CORE.Resource
Timing = CORE.Timing
Period = CORE.Period
Parameters = CORE.Parameters
Coding = CORE.Coding
Resource = CORE.Resource
Range = CORE.Range
Quantity = CORE.Quantity
Attachment = CORE.Attachment
BackboneElement = CORE.BackboneElement
DomainResource = CORE.DomainResource
ContactPoint = CORE.ContactPoint
ElementDefinition = CORE.ElementDefinition
Extension = CORE.Extension
HumanName = CORE.HumanName
Address = CORE.Address
Ratio = CORE.Ratio
SampledData = CORE.SampledData
Reference = CORE.Reference
CodeableConcept = CORE.CodeableConcept
Identifier = CORE.Identifier
Narrative = CORE.Narrative
Element = CORE.Element
###*
Embedded class
@class MedicationAdministrationDosageComponent
@exports MedicationAdministrationDosageComponent as MedicationAdministrationDosageComponent
###
class MedicationAdministrationDosageComponent extends BackboneElement
constructor: (@json) ->
super(@json)
###*
The timing schedule for giving the medication to the patient. This may be a single time point (using dateTime) or it may be a start and end dateTime (Period).
@returns {Array} an array of {@link Date} objects
###
timingDateTime:-> if @json['timingDateTime'] then DT.DateTime.parse(@json['timingDateTime'])
###*
The timing schedule for giving the medication to the patient. This may be a single time point (using dateTime) or it may be a start and end dateTime (Period).
@returns {Period}
###
timingPeriod: -> if @json['timingPeriod'] then new Period(@json['timingPeriod'])
###*
If set to true or if specified as a CodeableConcept, indicates that the medication is only taken when needed within the specified schedule rather than at every scheduled dose. If a CodeableConcept is present, it indicates the pre-condition for taking the Medication.
@returns {Array} an array of {@link boolean} objects
###
asNeededBoolean:-> @json['asNeededBoolean']
###*
If set to true or if specified as a CodeableConcept, indicates that the medication is only taken when needed within the specified schedule rather than at every scheduled dose. If a CodeableConcept is present, it indicates the pre-condition for taking the Medication.
@returns {CodeableConcept}
###
asNeededCodeableConcept: -> if @json['asNeededCodeableConcept'] then new CodeableConcept(@json['asNeededCodeableConcept'])
###*
A coded specification of the anatomic site where the medication first entered the body. E.g. "left arm".
@returns {CodeableConcept}
###
site: -> if @json['site'] then new CodeableConcept(@json['site'])
###*
A code specifying the route or physiological path of administration of a therapeutic agent into or onto the patient. E.g. topical, intravenous, etc.
@returns {CodeableConcept}
###
route: -> if @json['route'] then new CodeableConcept(@json['route'])
###*
A coded value indicating the method by which the medication was introduced into or onto the body. Most commonly used for injections. Examples: Slow Push; Deep IV.
Terminologies used often pre-coordinate this term with the route and or form of administration.
@returns {CodeableConcept}
###
method: -> if @json['method'] then new CodeableConcept(@json['method'])
###*
The amount of the medication given at one administration event. Use this value when the administration is essentially an instantaneous event such as a swallowing a tablet or giving an injection.
@returns {Quantity}
###
quantity: -> if @json['quantity'] then new Quantity(@json['quantity'])
###*
Identifies the speed with which the medication was introduced into the patient. Typically the rate for an infusion e.g. 200ml in 2 hours. May also expressed as a rate per unit of time such as 100ml per hour - the duration is then not specified, or is specified in the quantity.
@returns {Ratio}
###
rate: -> if @json['rate'] then new Ratio(@json['rate'])
###*
The maximum total quantity of a therapeutic substance that was administered to the patient over the specified period of time. E.g. 1000mg in 24 hours.
@returns {Ratio}
###
maxDosePerPeriod: -> if @json['maxDosePerPeriod'] then new Ratio(@json['maxDosePerPeriod'])
###*
Describes the event of a patient being given a dose of a medication. This may be as simple as swallowing a tablet or it may be a long running infusion.
Related resources tie this event to the authorizing prescription, and the specific encounter between patient and health care practitioner.
@class MedicationAdministration
@exports MedicationAdministration as MedicationAdministration
###
class MedicationAdministration extends DomainResource
constructor: (@json) ->
super(@json)
###*
External identifier - FHIR will generate its own internal IDs (probably URLs) which do not need to be explicitly managed by the resource. The identifier here is one that would be used by another non-FHIR system - for example an automated medication pump would provide a record each time it operated; an administration while the patient was off the ward might be made with a different system and entered after the event. Particularly important if these records have to be updated.
@returns {Array} an array of {@link Identifier} objects
###
identifier: ->
if @json['identifier']
for item in @json['identifier']
new Identifier(item)
###*
Will generally be set to show that the administration has been completed. For some long running administrations such as infusions it is possible for an administration to be started but not completed or it may be paused while some other process is under way.
@returns {Array} an array of {@link String} objects
###
status:-> @json['status']
###*
The person or animal to whom the medication was given.
@returns {Reference}
###
patient: -> if @json['patient'] then new Reference(@json['patient'])
###*
The individual who was responsible for giving the medication to the patient.
@returns {Reference}
###
practitioner: -> if @json['practitioner'] then new Reference(@json['practitioner'])
###*
The visit or admission the or other contact between patient and health care provider the medication administration was performed as part of.
@returns {Reference}
###
encounter: -> if @json['encounter'] then new Reference(@json['encounter'])
###*
The original request, instruction or authority to perform the administration.
@returns {Reference}
###
prescription: -> if @json['prescription'] then new Reference(@json['prescription'])
###*
Set this to true if the record is saying that the medication was NOT administered.
@returns {Array} an array of {@link boolean} objects
###
wasNotGiven:-> @json['wasNotGiven']
###*
A code indicating why the administration was not performed.
@returns {Array} an array of {@link CodeableConcept} objects
###
reasonNotGiven: ->
if @json['reasonNotGiven']
for item in @json['reasonNotGiven']
new CodeableConcept(item)
###*
An interval of time during which the administration took place. For many administrations, such as swallowing a tablet the lower and upper values of the interval will be the same.
@returns {Array} an array of {@link Date} objects
###
effectiveTimeDateTime:-> if @json['effectiveTimeDateTime'] then DT.DateTime.parse(@json['effectiveTimeDateTime'])
###*
An interval of time during which the administration took place. For many administrations, such as swallowing a tablet the lower and upper values of the interval will be the same.
@returns {Period}
###
effectiveTimePeriod: -> if @json['effectiveTimePeriod'] then new Period(@json['effectiveTimePeriod'])
###*
Identifies the medication that was administered. This is either a link to a resource representing the details of the medication or a simple attribute carrying a code that identifies the medication from a known list of medications.
@returns {Reference}
###
medication: -> if @json['medication'] then new Reference(@json['medication'])
###*
The device used in administering the medication to the patient. E.g. a particular infusion pump.
@returns {Array} an array of {@link Reference} objects
###
device: ->
if @json['device']
for item in @json['device']
new Reference(item)
###*
Provides details of how much of the medication was administered.
@returns {Array} an array of {@link MedicationAdministrationDosageComponent} objects
###
dosage: ->
if @json['dosage']
for item in @json['dosage']
new MedicationAdministrationDosageComponent(item)
module.exports.MedicationAdministration = MedicationAdministration
|