Configuration Editor - MakeMKV Auto Rip

📁 Paths and Directories

Override MakeMKV Installation Directory Enable to specify a custom MakeMKV installation path (normally auto-detected)

MakeMKV Installation Directory Only set this if MakeMKV is installed in a non-standard location

Movie Rips Directory * Directory where ripped movies will be saved

Enable File Logging

Enabled Disabled

Whether to save operation logs to files

Log Time Format Time format for console and log timestamps

Log Directory * Directory where log files will be saved

💿 Drive Operations

Automatically Load Drives

Enabled Disabled

Automatically load/close optical drives before ripping

Automatically Eject Drives

Enabled Disabled

Automatically eject drives after ripping completion

Drive Load Delay (seconds) Delay time when loading drives to allow for manual drive closing (0 to disable)

🔍 Mount Detection

Mount Wait Timeout (seconds) Maximum time to wait for drives to mount media before starting rip (0 to disable)

Polling Interval (seconds) Polling interval to check for newly mounted drives

🎯 Ripping Behavior

Rip All Titles

All titles above minimum length Longest title only

Whether to rip all titles from disc or just the main/longest title

Ripping Mode Parallel processing is faster for destination SSDs, Sequential processing is better for HDDs

🖥️ Interface Behavior

Repeat Mode

Enabled Disabled

After ripping, prompt again for another round instead of exiting

🎬 MakeMKV Settings

Fake System Date

Date (leave blank for real date)

Time (optional)

Temporarily change system date for MakeMKV operations only. Leave blank to use real system date.
Note: Requires administrative privileges. System date is automatically restored after ripping operations complete.
Docker: Not supported in Docker containers - change host system date manually if needed.