0000 No error, beginning task 0001 No response from reader 0002 Invalid response data 0003 Time out for task or CMD 0004 Wrong parameter 0005 SDK is doing MSR or ICC task 0006 SDK is doing PINPad task 0007 SDK is doing Other task 0300 Key Type(TDES) of Session Key is not same as the related Master Key. 0400 Related Key was not loaded. 0500 Key Same. 0702 PAN is Error Key. 0D00 This Key had been loaded. 0E00 Base Time was loaded. 1800 Send “Cancel Command” after send “Get Encrypted PIN” &”Get Numeric “& “Get Amount” 1900 Press “Cancel” key after send “Get Encrypted PIN” &”Get Numeric “& “Get Amount” 30FF Security Chip is not connect 3000 Security Chip is deactivation & Device is In Removal Legally State. 3101 Security Chip is activation & Device is In Removal Legally State. 5500 No Admin DUKPT Key. 5501 Admin DUKPT Key STOP. 5502 Admin DUKPT Key KSN is Error. 5503 Get Authentication Code1 Failed. 5504 Validate Authentication Code Error. 5505 Encrypt or Decrypt data failed. 5506 Not Support the New Key Type. 5507 New Key Index is Error. 5508 Step Error. 550F Other Error. 6000 Save or Config Failed / Or Read Config Error. 6200 No Serial Number. 6900 Invalid Command - Protocol is right, but task ID is invalid. 6A00 Unsupported Command - Protocol and task ID are right, but command is invalid. 6B00 Unknown parameter in command - Protocol task ID and command are right, but parameter is invalid. 7200 Device is suspend (MKSK suspend or press password suspend). 7300 PIN DUKPT is STOP (21 bit 1). 7400 Device is Busy. E100 Can not enter sleep mode. E200 File has existed. E300 File has not existed. E400 Open File Error. E500 SmartCard Error. E600 Get MSR Card data is error. E700 Command time out. E800 File read or write is error. E900 Active 1850 error! EA00 Load bootloader error. EF00 Protocol Error- STX or ETX or check error. EB00 Picture is not exist. 2C06 no card seated to request ATR 2D01 Card Not Supported, 2D03 Card Not Supported, wants CRC 690D Command not supported on reader without ICC support 8100 ICC error time out on power-up 8200 invalid TS character received 8500 pps confirmation error 8600 Unsupported F, D, or combination of F and D 8700 protocol not supported EMV TD1 out of range 8800 power not at proper level 8900 ATR length too long 8B01 EMV invalid TA1 byte value 8B02 EMV TB1 required 8B03 EMV Unsupported TB1 only 00 allowed 8B04 EMV Card Error, invalid BWI or CWI 8B06 EMV TB2 not allowed in ATR 8B07 EMV TC2 out of range 8B08 EMV TC2 out of range 8B09 per EMV96 TA3 must be > 0xF 8B10 ICC error on power-up 8B11 EMV T=1 then TB3 required 8B12 Card Error, invalid BWI or CWI 8B13 Card Error, invalid BWI or CWI 8B17 EMV TC1/TB3 conflict* 8B20 EMV TD2 out of range must be T=1 8C00 TCK error A304 connector has no voltage setting A305 ICC error on power-up invalid (SBLK(IFSD) exchange E301 ICC error after session start FF00 Request to go online FF01 EMV: Accept the offline transaction FF02 EMV: Decline the offline transaction FF03 EMV: Accept the online transaction FF04 EMV: Decline the online transaction FF05 EMV: Application may fallback to magstripe technology FF06 EMV: ICC detected tah the conditions of use are not satisfied FF07 EMV: ICC didn't accept transaction FF08 EMV: Transaction was cancelled FF09 EMV: Application was not selected by kernel or ICC format error or ICC missing data error FF0A EMV: Transaction is terminated FF0B EMV: Other EMV Error FFFF NO RESPONSE 0008 err response or data 0009 no reader attached 000A did connection 000B mono audio is enabled 000C audio volume is too low 000D task or CMD be canceled 0E00 Authorization Accepted 0E01 Unable to go online 0E02 Technical Issue 0E03 Declined 0E04 Issuer Referral transaction 0F00 Accept the online transaction 0F01 Decline the online transaction 0F02 Request to go online 0F03 Transaction is terminated 0F05 Application was not selected by kernel or ICC format error or ICC missing data error 0F07 ICC didn't accept transaction 0F0A Application may fallback to magstripe technology 0F0C Transaction was cancelled 0F0D Timeout 0F0F Other EMV Error 0F10 Accept the offline transaction 0F11 Decline the offline transaction 0F21 ICC detected tah the conditions of use are not satisfied 0F22 No app were found on card matching terminal configuration 0F23 Terminal file does not exist 0F24 CAPK file does not exist 0F25 CRL Entry does not exist 0FFE Return code when blocking is disabled 0FFF Return code when command is not applicable on the selected device